INSTALLATION AND OPERATION MANUAL
CR3 CR5, and CR7 Charging Racks
Introduction
For PLUGGABLE EQUIPMENT, the socket-outlet shall be installed near the equipment and shall be
easily accessible.
In US and Canada a permanent connection of equipment to the mains supply by a power supply cord is not
permitted.
In Sweden, Norway, Finland, and Denmark the Charging Rack must be connected to a wall outlet with
protective earth (safety grounding). For other countries it is recommended to use a protective earth
connection.
• Suomi: Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan.
• Norge: Apparatet må tillkoples jordet stikkontakt.
• Sverige: Apparaten skall anslutas till jordat uttag.
• Danmark: Apparatets stikprop skal tilsluttes en stikkontakt med jord som giver forbindelse til stikprop-
pens jord.
1.4 Regulatory Compliance Statements (EU and EFTA only)
This equipment is intended to be used in the whole EU & EFTA.
This equipment is in compliance with the essential requirements and other relevant provisions of EMC
Directive 2014/30/EU, LVD Directive 2014/35/EU and of Directive 2015/863 (RoHS3) amending 2011/65/EU.
The complete Declaration of Conformity is found at https://www.ascom-ws.com/doc.
The product is marked with
.
1.5 Regulatory Compliance Statements (USA and Canada only)
FCC Compliance Statements
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-3 (B)/NMB-3(B)
Modifications
Changes or modifications to the equipment not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
TD 92480EN / 30 October 2020 / Ver. L
4
To Next Page
Loading...
Need help?
General