ASCOM Elise3 Lite User Manual

TD 92679EN
22 November 2013 / Ver. G
Installation Guide
Elise3
8
3. Description
Flashing patterns
Figure 4. LED indications
* also used if the Power parameter conflicts with the actual setup.
Red
Red
Blue
Blue
Yellow
Yellow
Status LED
Blue
Mode LED
Blue
Blue
Yellow
Yellow
Blue
Status OK
Starting up/shutting down
Feedback (1 sec.)
Error/fault
Warning
Boot mode
Demonstation mode
Waiting for automatic
startup (1 min.)
Troubleshoot mode and
during firmware upgrade
Mass storage mode
Standby module synchronized
Standby module during
synchronization
Yellow
Power LED
Blue
Blue
Yellow
Status LED
Mode LED
Blue
Blue
Confirmation is done and settings
can be activated
Secured settings
Indicates that manual confirmation is required
Red
Power LED
Closing down caused by
low voltage
Power
Power OK
Blue
Red
Low voltage*
Active module during
synchronization
Active module synchronized
Blue
Blue
Red
Blue
3.4 Operating Mode
Besides normal operation the Elise3 can be operated in three other modes, that is, Boot
Mode, Demonstration Mode and Troubleshoot Mode.
3.4.1 Normal Operation
All configuration and settings for the Elise3’s software, such as m
aintenance, software
upgrade and troubleshooting, are performed in the web user interface described in the
product’s user documentation.
3.4.2 Boot Mode
If the software cannot be accessed, the Elise3 can be set in Boot Mode from the web user
interface. From this interface, it is possible to install new software, start Troubleshoot Mode,
see settings and to reset the module back to factory default settings
1
.
Placing the Elise3 in Boot Mode is performed manually by the user but if the Elise3 detects
several major errors the module can place itself in Boot Mode.
See 5. Working in Boot Mode on page 27.
1. Network settings such (IP address, Host name, etc.) will not be changed when resetting back to factory default.

ASCOM Elise3 Lite Specifications

General

Brand	ASCOM
Model	Elise3 Lite
Category	Server
Language	English