Need help?Do you have a question about the ASCOM H952T and is the answer not in the manual?
General| Brand | ASCOM |
|---|---|
| Model | H952T |
| Category | Transmitter |
| Language | English |
Declares compliance with R&TTE Directive 1999/5/EC, discussing frequency rules and licensing requirements.
FCC compliance for Class B digital device, covering interference, operation conditions, and modifications.
Details the function of connectors J100, J101, J102, J103, and J200 on the unit's circuit board.
Describes switches SW100, SW200 and indicator LEDs (LED100, LED201, etc.) on the circuit board.
Covers program memory IC101 and adjustable components like potentiometers and coils.
Guidelines for mounting the unit vertically, including dimensions and recommended spacing for service.
Procedure for releasing the cover and fastening units together or to a wall.
Describes three methods for routing cables from the unit, with warnings about openings.
Details connecting data/speech buses via modular cabling or twisted-pairs and control equipment.
Instructions for connecting power supply, including fuse recommendations, and setting the unit's address.
Guidance on connecting the antenna coax cable, preventing water ingress, and isolation methods.
States that reference frequency, VCO frequency, and output power are factory-set.
Explains how to connect the SP-bus to the module using twisted-pair cables.
Details rules for speech bus termination resistor (R100) when using multiple speech transmitters.
Instructions for assembling TNC coax connectors, including parts, dimensions, and soldering.
Instructions for assembling PL259 (UHF) coax connectors, including cable preparation and soldering.
To Next Page
