TD 92022EN
3 July 2013 / Ver. G
Installation Guide
H/U952T Terminal Transmitter
12
4 Parameter Settings
All parameters must be set in the U/H952 Flash PROM IC 101, before the tuning procedure.
The instruction for programming fixed equipment is described in General Description PCPAR,
TD 90799GB. Not
e that licence is required when FOM/SFO or FL is used
.
1 Open PCPAR and select software S952T.
2 Set the Terminal Transmitter frequency in Hz.
3 Set the channel spacing.
4 If there is speech in the system check:
• Subtone frequency (default 127.3 Hz).
When FL (frequency locking) is used check:
• That frequency locking is enabled with th
e right refe
rence frequency.
5 When FOM or SFO is used this has to be enabled with the right offset.
6 If the Terminal Transmitter is to be used wit
h
old central software that do not
support U/H952T (specified in the parameter list), set the Terminal Transmitter to
act as an U/H950T.
7 If FOM/SFO or FL is used, enter the required licence code.
8 When you have edited the parameter list, download the changes to flash prom
IC 101 and exit PCPAR.
To Next Page
Loading...
Need help?
General
