ascon M3 Series - Page 28

é 1
é 0
é 1
éIn.sécala
éF.sécala
pass
st.tM
sa.Op
Addr
rt.lo
énone
é Off
é Off
é Off
é Off
A3L.b
t.LbA
t.Fil
In.sh
é 1
é100:0
é 0:5
énone
s.p.s.U
t.h.s.U
Op.Hs
A2hy
st.Op
A2L.b
rt.Hi
é 0:5
A3hy
é Off
d.Err
éL. réange
éH. réange
é 0
27
4 - Operations
Start-up Setpoint
(if option installed)
s.p. l…s.p. H
Start-up hold time
(if option installed)
0…500 min.
Output high limit during
Start-up
(if option installed)
5.0…100.0%
AL2 hysteresis
0.1…10.0% of span [1]
AL2 latching
and blocking
functions
none / Ltch
bloc
/ Lt.bL
AL3 hysteresis
0.1…10.0% of span [1]
AL3 latching
and blocking
functions
none / Ltch
bloc
/ Lt.bL
LBA delay
(see page 31)
0ff= sensor break
1…9999 sec LBA
Filter time constant
0ff/ 1…30 sec
Input shift
0ff/ -60…60 digits
Error dead band
(PID algorithm only)
0ff/0.1…10.0 digits
Soft-start output value
(PID algorithm and
t.Mod =0ff)
0ff/0.1…100.0%
Password entry
only if
Code value
<5000 (see pages 35…37)
Soft-start
activation time
(only if
st.Op different than
0ff)1…9999 sec.
Output safety value
0.0…100.0%
(-100.0…100.0% for
heat/cool)
Communication address
(if option installed)
0ff/ 1…247
Retransmission
low range
(if option installed)
full scale
Retransmission
high range
(if option installed)
full scale
Back to the 2nd parameter group
Direct access
to the configuration
(pages 35 … 37)