37
4 - Operations
Code entry
from 0 to 4999
(
33 default from factory)
The entered password must correspond to
the one store in the
Code parameter.
Password entry
only if
Code value <5000
YES
NO
A
Direct access to the configuration
A From parameterisation (see page 27).
B At the first power on when the
controller is not configured:
In this situation, the controller has its outputs and inputs not active.
This situation ends when a correct configuration code is entered.
Note
[1] Table of the supported Engineering
Units.
* For inputs from thermocouple or
resistance thermometer, the choice
is between °C and °F only.
[2] Minimum Range 100 digits.
[3] To avoid free parameter access
insert 5000…9999
mV
nU
Volt
U
mA
MA
Centigrade degrees*
°C
Ampere
Fahrenheit degrees *
°f
A
Bar
bAr
PSI
none
none
psI
Rh
rh
pH
ph
To Next Page
Loading...