ASG DTT-10 - Calibration and Transducer Status

ASG, Division of Jergens, Inc.
15700 S. Waterloo Road | Cleveland, OH 44110-3898 | Phone: (888) 486-6163 | Fax: (216) 481-4519 | Email: asginfo@asg-jergens.com | www.asg-jergens.com
Page 17 of 23
Main Menu (Continued)
Transducer State
Statistics
This is used to check the status of the transducer. If you suspect that your transducer
has sustained an overload, check the status of the transducer immediately.
• To access the Transducer State menu, press and hold the MENU/ESC key to
access the main menu. Use the UP or DOWN arrow keys to move the cursor to
TRANSDUCER STATE and press ENTER.
• Place the tester horizontally on a at level surface and go to the main menu page
• Use the UP and DOWN arrow keys to move the cursor point to TRANSDUCER
STATE and press the ENTER key
• The display will show TRANSDUCER STATE menu page. Press the ESC key to
return to the main menu page.
• If the % offset is between 5%-10%, please contact ASG to arrange a
recalibration of your tester
• If the % offset is greater than 10%, please contact ASG to arrange for repair or
replacement
• These values are given only as an indicator – the need for repair may vary
according to the individual characteristics of the transducer
The statistics are calculated for all of the readings currently in the memory and
include: maximum, minimum, mean, std, cov., based on all units in memory.
• To access the Statistics menu, press and hold the MENU key to access the
main menu. Use the UP or DOWN arrow keys to move the cursor to MEMORY
and press ENTER. Use the UP or DOWN arrow keys to move the cursor to
STATISTICS and press ENTER.
• Press the ESC key to return to the memory menu page
DTT Series Digital Torque Testers
User Manual
Calibration
ASG service technicians to calibrate the tester; please contact ASG for additional
calibration information.
ESC
0.0000
0.0000
0.0000
0.0000
000.00
DATE AND TIME
ESC ENTERDEC- INC+
PREV NEXT
mm/dd/yy: 00 00 00
hh:mm:ss: 00 00 00
FACTORY RESET
ESC ENTER
AUTO RESET OFF:
:
:
:
OFF
OFF
OFF
PASS-FAIL
AUTO MEMORY
AUTO PRINT