59
2. Frequency: Select the frequency band to configure professional settings.
3. Index: Indicates witch SSID is under setting.
4. SSID: A name whose length is less than 32 characters is used to identify a
wireless network.
5. Enable TX STBC: Enables or disables the Space Time Coding Block (STBC)
feature, as described in 802.11n specification, in transmitting (TX) direction.
6. Enable RX STBC: Enables or disables the Space Time Coding Block (STBC)
feature, as described in 802.11n specification, in receiving(RX) direction.
7. Set AP Isolated: Prevent wireless devices from communicating with each other
via router. This feature is useful if many guests frequently join or leave your
network. Select [Yes] to enable this feature or select [No] to disable.
8. Multicast Rate (Mbps): Setting transmission rate for multicast.
9. Short Guard Interval: Defines the length of time that the router spends for CRC
(Cyclic Redundancy Check). CRC is a method of detecting errors during data
transmission. Select Enable for a busy wireless network with high network
traffic.
10. DTIM Interval: DTIM (Delivery Traffic Indication Message) Interval or Data
Beacon Rate is the time interval before a signal is sent to a wireless device in
sleep mode indicating that a data packet is awaiting delivery. The default value is
three milliseconds.
11. Enable WMM: Enables or disables WMM capabilities in the driver. The WMM
capabilities perform special processing for multimedia stream data including
voice and video data.
12. Enable WMM APSD: Enable WMM APSD (Wi-Fi Multimedia Automatic
Power Save Delivery) to improve power management between wireless devices.
Select Disable to switch off WMM APSD.
13. Turbo QAM: 256-QAM (MCS 8/9) support. Wireless Mode must be set to auto.
14. Universal Beamforming: For legacy wireless network adapters which do not
support
beamforming, the router estimates the channel and determines the
steering direction to improve the downlink speed. (Also known as Implicit
To Next Page
Loading...
