Asko HIG1995AB - Induction Operation; Switching on and Power Setting; Residual Heat Indicator

Switching on and power setting
1. Press the key button.
A single audio signal sounds.
2. Place a pan in the middle of a cooking zone.
The APd registers a pan and a flashing ‘-’ appears in the display.
If you don’t do anything else, the cooking zone will switch off
automatically after 10 seconds.
3. Press the + or - button, or the << or >> button to select the desired
setting. The cooking zone starts automatically in the level that has
been set (when a pan is detected).
• If you press the + or - button first, level 6 appears.
• If you press the >> button first, level 12 + ‘boost’ appear in the
display. This is power level ‘boost’ and you can use this setting if
you want to bring dishes to the boil quickly.
• If you press the << button first, level 1 will appear.
NOTE!
If the APd function is switched off, activate a cooking zone using the on/off button.
Automatic pan detection (APd)
Once the hob is switched on, if a pan is placed on an inactive cooking zone, the corresponding
control will light up and can be operated immediately (without operating the on/off button). If the
cooking zone is not switched on within 10 seconds it will switch itself off again.
The cooking zone can be reactivated by removing the pan and replacing it on the cooking zone or
by using the on/off button.
This function is active by default, but can also be switched off. This is done by switching the hob off
and operating the ‘Menu’ and ‘on/ off button’ on the left-hand control panel for 5 seconds. ‘APd OFF’
will appear on the display. By repeating this process, the function can be reactivated and the ‘APd
On’ will appear on the display.
NOTE!
If the hob doesn’t detect a pan, with or without iron content, after a power level has been set, the
display will continue to flash and the cooking area will remain cold. If no pan with or without iron
content is placed on the zone within one minute, the cooking zone will switch off automatically.
Residual heat indicator
After use, the cooking zone used may stay hot for several minutes. As
long as the cooking zone is still hot, an ‘H’ will be visible in the display.
23
Induction operation