What to do if Asko SIVK9DTA shows error code F8 or F08?
Error code F8 or F08 on your Asko hob indicates that the appliance has overheated. The hob was automatically switched off to prevent damage. To resolve this, allow the appliance to cool down completely. After it has cooled, you can start cooking again, but it's recommended to use a lower power setting to prevent future overheating.
What to do if my Asko Hob shows error code F00?
If your Asko Hob displays error code F00, it indicates that the control panel is dirty or has water on it. Clean the control panel to resolve this issue.
What to do if my Asko SIVK9DTA Hob shows error code FA?
If your Asko Hob displays error code FA, it indicates that the mains voltage is too low. Contact your energy supplier to address this issue.
Why does the display keep flashing when I switch on a cooking zone on my Asko SIVK9DTA Hob?
If the display keeps flashing when you switch on a cooking zone on your Asko Hob, the pan you are using is not suitable for induction cooking, or has a diameter of less than 12 cm. Use a suitable pan.
What does 'br' on my Asko SIVK9DTA display mean?
When ‘br’ appears in the display of your Asko Hob and the touch controls are not working, it indicates that the bridge function is activated. Deactivate the bridge function.
Why does a fuse blow as soon as my Asko Hob is switched on?
If a fuse blows as soon as your Asko Hob is switched on, it suggests that the hob has been wrongly connected. Check the electrical connections.
What to do if my Asko Hob shows error code F99?
If your Asko Hob displays error code F99, it means you have pressed two or more buttons at the same time. Avoid pressing multiple buttons simultaneously.
What does error code F7 mean on my Asko Hob?
Error code F7 on your Asko Hob indicates that the ambient temperature is not good. To resolve this, switch off all heat sources near the cooking plate.
What does error code FAN mean on my Asko Hob?
Error code FAN on your Asko Hob means that the air circulation is not good. Make sure the venting holes under the cooking plate are open.
What does error code F8 and F08 mean on my Asko Hob?
Error codes F8 and F08 on your Asko Hob indicate that the appliance has overheated. The appliance has been switched off because of over heating. Allow the hob to cool down before using it again, and then start again on a lower setting.
To Next Page
General
