27
3) Process of Manual Dry Course
A. Power Button On
➔ “_ _ _” is displayed at 18:88 LED.
➔ “Check Filter” of Custom LED goes on and off before you press Start Button.
➔ “High” of initial Beeper goes on and the previous Beeper value is displayed when you switch
on the power.
B. Operation Selection
➔ Select operation with Course Switch/Button.
➔ “Check Filter” of Custom LED goes on and off before you press Start Button. Once the unit starts
operating, “Check Filter” goes off.
➔ Buttons operate as per 2-1.
➔ The selected Course/Dry Level/Temp Control/Time Dry/Beeper goes on and Custom LED displays
Dry/Cooling.
➔ Option LED may go on and off according to your selection.
C. Operation Process
➔ Once operation starts, LED of Custom LED goes off.
➔ Humidity data are not produced and Heater is controlled by the temperature set by Temp Control.
➔ Time is not changed but drying/cooling continues during the time set initially.
4) Process of Time Dry Course
A. Selection of Time Dry
➔ Course Selection foes off.
➔ Dry Level can not be selected (Default: “High”) but only Temp Control.
➔ Buttons operate as per 2-1 (Same as Manual Dry).
B. Operation Process
➔ The process is the same as Manual Dry.
➔ “Check Filter” of Custom LED goes off if you press Start Button.
To Next Page
Loading...
