29
2-4. Operation of Buttons
1) Power
A. The electric power switch turns on/off the display.
B. Automatic switch off function
1 Power is immediately switched off after an operation is done.
2 Power is switched off after 10 minutes if no button is selected while power is on.
C. Initial display when power goes on
1 LED of all courses goes on in order.
2 ā_ _ _ā is displayed at 18:88 LED.
2) Start/Pause
A. Normal Course is operated if you press the button after switching on the power.
B. Operation starts after you select one of 11 automatic and program courses.
C. If you press this button while the unit is in operation, the on-and-off indicator goes on and the machine
stops. If you press the button again, the operation is resumed.
D. If you press Pause Button, other buttons or the encoder switch does not function. That is, you can not
change the operation once it starts unless switching off the power.
1 Power is immediately switched off after an operation is done.
2 Power is switched off after 10 minutes if no button is selected while power is on.
3) Dry Level
A. If you press this button, the following is displayed in order.
Normal-More Dry-Very Dry-Damp Dry-Less Dry-Normal
B. Each level targets humidity as follows.
C. You can select all levels in Sensor Dry Course but none in Manual Dry Course.
Dry Level Target Humidity
Damp Dry 80%~92%
Less Dry 88% ~ 96%
Normal 92% ~ 100% or higher
More Dry 94% ~ 100% or higher
Very Dry 96% ~ 100% or higher
To Next Page
Loading...
