EasyManua.ls Logo

Asko WM70 - WM70.1 Option Selection

Asko WM70
57 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Service manual WM70
29
Start/stop
Press to start a programme.
Press and hold for three seconds
to stop or change a programme.
Door opening
Press once to open the washer
door.
Option selection WM70.1
Turn /
Press
Program Description
8. Wool/Hand A gentle laundry program for wool, silk and garments
that should be washed by hand. The highest
available temperature is 40°C. This program
has a short spin. The maximum spin speed is 800
rpm.
9. Rinse program This program performs one cold rinse cycle +
spin. Suitable for laundry that just needs to be
dampened and for cleaning cloths and mops
10. Spin/Drain Used to just spin the wash. If you only want to
drain the machine of water, select the. symbol
(no spin)
Press the start/Stop-button to start the program
Press
Description
40°
30°
20°
95°
60°
50°
3ELECT THE TEMPERATURE BY PRESSING THE BUTTON UNTIL THE ,%$ BY THE DESIRED TEMPERATURE LIGHTS
You can select temperatures between 20°C and 95°C. For Wool/Hand you cannot choose a temperature
higher than 4C, when choosing Synthetics or Easy care the maximum temperature is 60°C.
400 1600
120 0
800
s 3ELECT THE SPIN SPEED BY PRESSING THE BUTTON UNTIL THE ,%$ BY THE DESIRED SPEED LIGHTS
s 9OU CAN SELECT SPEEDS BETWEEN  AND  RPM .O SPIN OR .O DRAIN ! SPIN WITH A SPEED OF 
800 rpm is always a short spin. (Some models up to 1200 respectively 1400 rpm)
s 9OU CANNOT CHOOSE A SPIN SPEED HIGHER THAN  RPM FOR 7OOL (AND
and Synthetics
s .O SPIN
MEANS THAT THE PROGRAM DOES NOT INCLUDE A SPIN CYCLE AND ENDS BY DRAININGs .O DRAINING )means
that the program does not include a spin cycle and ends with the water from the final rinse still
in the machine. The washing will remain covered by the water from the final rinse and therefore will
not become creased
s )F YOU ONLY WANT TO DRAIN THE MACHINE OF WATER SELECT THE 3PIN DRAIN PROGRAM
Aviable only on some models with 6 options.
s 3ELECT 3UPER WASH
)by pressing the button by the symbol.
s !N ,%$ NEXT TO THE BUTTON LIGHTS WHEN THIS OPTION IS ACTIVATED
s 3UPER WASH CAN BE SELECTED TO BETTER DISSOLVE DIFlCULT STAINS AND HEAVY SOILING ON CLOTHING 4HE MAIN WASH TIME IN
cold water is extended by approximately six minutes. The main wash time is also extended.
s 4HIS OPTION CANNOT BE SELECTED WITH THE AUTOHEAVYWHITE AND QUICK COLOURS PROGRAMMS
s 3ELECT (IGH WATER LEVEL
)by pressing the button by the symbol.
s !N ,%$ NEXT TO THE BUTTON LIGHTS WHEN THIS OPTION IS ACTIVATED
s (IGH WATER LEVEL MEANS THAT ADDITIONAL WATER IS USED DURING THE MAIN WASH AND RINSE CYCLES 4HIS OPTION CAN BE USED
with all programmes except Wool/Hand, rinse and spin/drain.
.OTE
The machine takes in the additional water for the high water level about 15 minutes after the main wash has started.
s 5SE THE 3UPER RINSE )option if you want to increase the number of rinses. The maximum number of rinses is
seven and varies depending on the selected programme. This option cannot be selected with rinse and spin/drain
s 3ELECT 3UPER RINSE BY PRESSING THE BUTTON BY THE SYMBOL
s !N ,%$ NEXT TO THE BUTTON LIGHTS WHEN THIS OPTION IS ACTIVATED
s 3ELECT $ELAYED 3TART
) by pressing the Time button. You can delay the start by between 1 and 24 hours,
THE TIME IS SHOWN IN WHOLE HOURS 4HE ,%$ NEXT TO THE 4IME BUTTON SHOWS THAT $ELAYED 3TART HAS BEEN
activated.
The machine counts down 1 hour at a time and starts after the selected delay.
.OTE
Make sure the detergent compartment is completely dry before you add detergent, otherwise there is
a risk that the detergent will clump before the machine starts.
Press the Start/Stop button to start program

Related product manuals