Asko WM70 - Page 47

Service manual WM70
47
5. Remove the plastic plugs covering
the holes for the hinge pins and switch
location
Method for removing plastic plugs, lock
and catch located on the machine and
the door:
Carefully push the plug, catch or lock
upwards with a flat screwdriver. as the
picture shows.
6. Carefully remove the catch and plastic
plug on the door (according to the
method above) and switch location.
7. Carefully remove the lock and plastic
plug on the machine (according to the
method above) and switch location.
8. Screw the hinge pins securely into
place on the corresponding side of the
machine.
9. Slacken off the screws for the lower
hinge on the corresponding side of the
machine. This must be done to hang the
door.