Assa Abloy CLIQ - CLIQ Web Manager Einrichten

36
EN
Bluetooth pairing guide (PAN)
The Mobile PD firmware can only connect with smart devices running Android
version 4.0 (ICS) or higher.
To find the Android version on your smart device:
1 Start the Settings app.
2 Choose About phone.
 You can identify the Android version of your device.
CLIQ Web Manager einrichten
Before pairing the Mobile PD with a PAN enabled smart device, do the following
in CLIQ Web Manager:
Note!
Changes to the connection settings must be transferred via cable to the mo-
bile programming device: If the Mobile PD connection settings are changed, the
new configuration needs to be installed in the Mobile PD using a USB on-the-go
cable. For more information, see the user guide for CLIQ Web Manager.
1 Make sure that the Mobile PD Bluetooth settings are empty (not configured
for DUN, see
“DUN support”, page 55).
2 Verify that the Mobile PD firmware is upgraded to at least version 2.10.0.
Firmware 2.10.0 (or higher) supports Bluetooth connection to smart devices.
 You have set up the CLIQ Web Manager.
Android
I