EasyManuals Logo

Assa Abloy PDU8500 Series User Manual

Assa Abloy PDU8500 Series
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
Copyright © 2020-2021, ASSA ABLOY Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Inc. is prohibited.
7
Holes
in Door
Door Gasket
Mating Pull-Cylinder
Housing Assembly
Mating Pull
Assembly
Door
2.2.3 Install Mating Pull
Place the Mating Pull Assembly on the Door.
Install the Mating Pull-Cylinder Housing Assembly
with the Door Gasket through the holes in the Door.
Make sure that the posts that are sticking out from the
Mating Pull-Cylinder Housing Assembly go through
the holes in the door.
2.2.4 Install Actuator Post Assembly
Install the Actuator Post Assembly on top of the opening in
the Door to attach to the Cylinder Housing.
Make sure that the Push Rod goes through the bottom hole.
Apply a small drop of Threadlocker to the threads of the Flat
Head Socket Cap Screw (
1
/
4
"-20).
Install the Flat Head Socket Cap Screw (
1
/
4
"-20)
and secure until tight.
CAUTION: Make sure that the Spring Tube-Spring
and the Push Rod are inserted into the
Actuator Post Assembly.
Door
Flat Head
Socket Cap
Screw
Spring
Tube-Spring
Actuator Post
Assembly
Mating Pull
Assembly
Cylinder Housing
Push Rod
Place one side of Alignment Bushing and Spacer in the
hole of the door.
When placing the other side of the Alignment Bushing
in the hole of the door, orient the pin and push into
other side of spacer.
Position the Mating Pull Assembly against the exterior
side of the Door.
Apply a small drop of Threadlocker to the threads of the
Stud (
5
/
16
"-18).
Slide the Metal Washer onto the Stud (
5
/
16
"-18) until
it sits against the Conehead Union (
5
/
16
"-18) on the
interior side of the Door.
Slide the Conehead Union (
5
/
16
"-18) with the Metal
Washer through the Alignment Bushing in the hole in
the Door.
Screw the Conehead Union (
5
/
16
"-18) and the Stud
(
5
/
16
"-18) into the Mating Pull Assembly Post until tight.
CAUTION: Depending on weatherstripping, extra metal
washers provided may be required.
2.2.5 Install Vertical Door Mount
Metal
Washer
Alignment Bushing
and Spacer
Mating Pull
Assembly
Interior Side of
Door
Conehead
Union

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Assa Abloy PDU8500 Series and is the answer not in the manual?

Assa Abloy PDU8500 Series Specifications

General IconGeneral
BrandAssa Abloy
ModelPDU8500 Series
CategorySafety Equipment
LanguageEnglish

Related product manuals