62
For example after the All Pass SRQ has been enabled, when the test(s) have
finished with pass indications the instrument will set the hardware SRQ line and
output the status byte of 41 hex. This means that bit 6 and bit 0 are set to a value
of 1. After reading the status byte the status byte value will change to 01 hex.
FOR MORE INFORMATION ON IEEE (GPIB) PLEASE CONTACT
The Institute of Electrical and Electronic Engineers, Inc.
345 East 47th Street,
New York, NY 10017
1-212-705-7018 (Communications Society of IEEE)
Internet: www.ieee.org
To Next Page
Loading...
