Astralux 9300A - Needle Position of Zigzag

6-7 Needle position of zigzag
- Choose patterns #5, zigzag 7 mm.
1) Remove face plate
2) Loosen screw (a) of needle bar driving
rod pin (b). (1)
3) Adjust needle by pushing (b) clockwise /
counter-clockwise.
Clockwise left
Counter-clockwise right
4) Make sure needle drops on left / right of
needle hole with even distance to the
edge of needle hole, and then fasten the
screws. (2)
5) After the adjustment of z/z needle
position, re-confirm the needle position
of zigzag.
Needle hole
Needle
15
2
a
b
1