Astralux 9300A - Drop Point of Needle

6-20 Drop point of needle
- Choose patterns #25.
1) Remove the cord reel cover.
2) To check if the feed rock crank (A), feed
rock rod (B) and feed crank (C, D) are
smooth. (1)
3) Place a piece of blank paper on top of
needle plate and use presser foot to
secure paper by pulling presser bar lifter
lever down. (2)
4) Adjust the speed limiting adjustment
lever to the slow speed and step on the
foot controller lightly. Check if the needle
can drop in the same place while
moving forward and backward.
5) If it did not in the same place:
When the stitch is too tight, adjust the
screw of feed crank counter-clockwise
(C), and the needle will go frontward ( ).
(1, 3)
When the stitch is too loose, adjust the
screw of feed crank clockwise(C), and
the needle will go backward ( ). (1, 3)
28
1
2
a
A
B
C
D
3
Stitch is too tight
Stitch is too loose