Atag DW8114XT - User Manual

Questions and Answers

J
Joshua DavisAug 26, 2025
How to improve drying in my Atag Dishwasher?
- G
  George RamosAug 27, 2025
  If your Atag Dishwasher leaves dishes not dry enough, ensure the Auto Open option is activated. Make sure the dishwasher is fully loaded for optimal drying. Check the rinse aid level and increase the dosage if necessary. If you are using all-in-one detergents with the TAB setting activated but the drying effect is insufficient, switch detergents or deactivate the TAB setting and top up with salt and separate rinse aid.
J
Jeffrey AyersAug 25, 2025
Why does my Atag DW8114XT leave spots or films on the dishes?
- K
  Kenneth PittmanAug 25, 2025
  If your Atag Dishwasher leaves spots or films on the dishes, the cause could be an incorrect rinse aid dosage. Refer to the Settings section to adjust it. If you're using all-in-one detergent with the TAB setting activated but the drying effect is insufficient, switch detergents or deactivate the TAB setting and add salt and separate rinse aid. Ensure the salt compartment is full and the water softener setting is correct. Check the salt compartment lid is tightened properly. If you notice etching on crystal, wash crystal at a low temperature with a conservative amount of detergent.
J
James HebertAug 25, 2025
How to fix Atag Dishwasher if the dishes are not clean?
- N
  Nancy LongAug 25, 2025
  If your Atag Dishwasher isn't cleaning dishes properly, several factors could be at play. Ensure the spray arms aren't blocked by dishes and can rotate freely. Clean the spray arms and middle basket's spray pipes. Select a program with Intensive mode for heavily soiled dishes. Check your detergent dosage, using the correct amount for your water hardness, and ensure your detergent isn't old. Load the dishes correctly, avoiding overcrowding or blocking. Make sure glasses and cups are stable. Verify the filters are correctly fitted and that the drainage pump stop is in place.

Atag DW8114XT Specifications

General

Type	Freestanding
Place settings	14
Noise level	44 dB
Water consumption	9.5 liters
Number of programs	8
Delay timer	Yes
Half load option	Yes
Dimensions (HxWxD)	850 x 600 x 600 mm