EN 30
MAINTENANCE
Cleaning the filters
Cleaning cast iron grid
1. Remove the cast iron grid from the extraction inlet.
• Clean the cast iron grid with hot water and neutral soap, without using abrasive sponges (do
not use detergents!). Do not wash the cast iron grid in a dishwasher.
Cleaning the grease filter
1. Pull the grease filter out of the extraction inlet using the two flaps.
• Clean the grease filter every month of operation (or when the filter saturation indication
system indicates this necessity. This will maintain good performance of the extractor and
prevent a potential fire hazard, caused by excessive grease build-up.
• Clean the filter with a non-aggressive detergents, preferably by hand or els in the
dishwasher, which must be set to a low temperature and a short cycle.
Odour filter (recirculation use)
Replace the odour lter at least once a year depending on the intensity of use of operation (or
when the filter saturation indication system indicates this necessity). Carefully remove the filter; it
is positioned with magnets on the sides.
When inserting the new filter, pay attention to the arrow that indicates the direction of the airflow.
Put the filter back and reset the memory of the filter saturation indication on the appliance.
To Next Page
Loading...
