This operation is for confirming measurement values at
each mode when or after concentration scale (Conc) is set.
① Press START/STOP to stop measurement.
② "StoP" will be displayed on the measurement value
display.
③ Press SCALE key once and the last value will be
displayed.
④ Press SCALE again to display results in the next
measurement mode, (i.e. nD, Brix, Conc, in turn).
Pressing SCALE while Conc is displayed will bring up
"SET UP" mode.
⑤ "StoP" will be displayed if left inactive for 10 seconds.
To Next Page
