AT&T 3G MicroCell User Manual

19
OCTOBER 24, 2008 DRAFT
OCTOBER 24, 2008 DRAFT
GPS Antenna Extension Installation
• Plug one end of the device into the GPS antenna extension connector and place the other end
as close as possible to the nearest window.
• Recycle power on the MicroCell to restart authentication.
• If the extension is successful, the GPS status LED will turn to steady green in 10 to 30 minutes. You
must then allow authentication to continue until the 3G status LED turns to steady green.
• Disconnect the GPS antenna extension when you’re done and store it in a safe place.
If this procedure fails, contact Customer Support at 800.331.0500 for assistance.
ANT
PC
Ethernet
Power
Reset
T13884
AT&T 3G
MicroCell
™
GPS Antenna
Extension
Reset Button
Note: Pressing the Reset button restores the MicroCell to its factory default settings. Do not press
the Reset button unless you have been asked to by Customer Support.

AT&T 3G MicroCell Specifications

General

Brand	AT&T
Model	3G MicroCell
Category	Extender
Language	English