Appendix
143
Troubleshooting
Incomplete messages.
If a caller leaves a very long message, part of it may be lost when
time you have set.
If the caller pauses for longer than seven seconds, the system
stops recording and disconnects the call.
If the system’s memory becomes full during a message, the
system stops recording and disconnects the call.
and disconnect the call.
Diculty hearing messages.
Press VOLUME+ to increase the telephone base speaker
volume.
Press DIR/VOLUME to adjust the message playback volume
on a handset.
System does not answer aer the correct number of rings.
• Make sure that the answering system is on. ANS ON should
show on the handset and the
/ANS ON/OFF light on the
telephone base should be on.
• If toll saver is activated, the number of rings changes to two
when you have new messages stored (page 108).
• If the memory is full or the system is off, the system will answer
after ten rings.
system used by your telephone service provider.
If you subscribe to voicemail service, change the number of rings
so that your answering system answers before your voicemail
(page 108). To determine how many rings activate your
To Next Page
Loading...
Need help?
General
