AT&T CL83143 Abridged User Manual

Answering system
42
Answering system settings
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access code
is 19.
To change the remote access code:
Using a cordless handset or the telephone base:
1. When the handset or telephone base is in idle mode, press
MENU/SELECT to
enter the main menu.
2. Press
qCID or pDIR to scroll to Answering sys, then press MENU/SELECT.
3. Press
qCID or pDIR to scroll to Ans sys setup, then press MENU/SELECT.
4. Press
qCID or pDIR to scroll to Remote code, then press MENU/SELECT.
5. Use the dialing keys to enter a
two-digit number. Press MUTE/DELETE on the
handset or X/DELETE on the telephone base to backspace and delete a digit.
6. Press MENU/SELECT to save the setting.
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every ten seconds. By default, the message
alert tone is set to off.
There is no audible alert at the handset.
To change the setting:
Using a cordless handset or the telephone base:
1. When the handset or telephone base is in idle mode, press
MENU/SELECT to enter
the main menu.
2. Press
qCID or pDIR to scroll to Answering sys, then press MENU/SELECT.
3. Press
qCID or pDIR to scroll to Ans sys setup, then press MENU/SELECT.
4. Press
qCID or pDIR to scroll to Msg alert tone, then press MENU/SELECT.
5. Press
qCID or pDIR to choose On or Off.
6. Press
MENU/SELECT to save the setting.

AT&T CL83143 Specifications

General

Brand	AT&T
Model	CL83143
Category	Cordless Telephone
Language	English