Answering system
46
About the answering system
Options while a message is being recorded:
Press qCID/VOLUME or pDIR/VOLUME on the handset to adjust the call
screening volume.
Press OFF/CANCEL to temporarily silence the call screening.
Press MENU/SELECT to temporarily turn on the call screening if call screening
is set to off.
Press /SPEAKER to broadcast the announcement and the incoming message
through the speakerphone. Press again to turn off the speakerphone.
Call intercept
While screening a call, you can stop recording and speak to the caller by pressing
PHONE/FLASH on the handset or /SPEAKER on the telephone base.
Temporarily turning off the message alert tone
If the message alert tone is turned on, the telephone base beeps every ten
seconds when there are new messages. Pressing any telephone base key
(except /HANDSET LOCATOR) temporarily silences the message alert tone.
If you press X/DELETE when in idle mode to temporarily turn off the message
alert tone, there is a voice prompt directing you to press X/DELETE again
to delete all old messages. The message alert tone is temporarily off. Only
press X/DELETE a second time if you wish to erase all old messages in your
answering system.
The message alert tone resumes when you receive another message.
•
•
•
•
To Next Page
Loading...
Need help?
General
