10
Getting started
Telephone base and charger installation
Install the telephone base and charger, as shown below.
The telephone base is ready for tabletop use. If you want to change to wall-
mounting, see Installation options on page 15 for details.
IMPORTANT INFORMATION
f Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at https://telephones.att.com or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
f The power adapters are intended to be correctly oriented in a vertical or oor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Plug the power adapter into a power outlet not
controlled by a wall switch.
Charger installation
Telephone base installation
Raise the antenna.
Plug the small end of the telephone
base power adapter into the power
adapter jack on the back of the
telephone base.
Route the telephone line
cord through this slot.
Plug one end of the telephone line cord
into a telephone jack or a DSL lter.
Plug the large end of the telephone
base power adapter into a power outlet
not controlled by a wall switch.
If you have DSL
high-speed Internet
service, a DSL lter
(not included) is
required.
Route the power adapter
cord through these slots.
Plug the other end of the
telephone line cord into the
telephone jack on the back
of the telephone base.
To Next Page
Loading...
Need help?
General
