Telephone operation
43
Volume control
Using a cordless handset:
You can set the listening volume to one of six levels.
While on a call, press qCID/VOLUME to decrease or
press pDIR/VOLUME to increase the listening volume.
Using the telephone base:
You can set the listening volume to one of eight
levels.
While on a call, press q/VOL to decrease or
p/VOL to increase the listening volume.
Notes:
f Handset and speakerphone volume settings are independent.
f When the volume reaches the minimum or maximum setting, you hear two beeps.
Call waiting
If you subscribe to call waiting service from your telephone service provider,
and someone calls while you are already on a call, you hear two beeps.
f Press
PHONE/FLASH on the handset or FLASH/PTT on the telephone base
to put your current call on hold and take the new call.
f Press
PHONE/FLASH on your handset or FLASH/PTT on your telephone
base at any time to switch back and forth between calls.
Note:
f If the Smart call blocker is on and in screening mode, and you receive a call waiting call:
- If you have already picked up a screened call, the telephone checks whether the call waiting number can be found
in the directory, block list or allow list. It also checks whether the caller name is in the star name list. After that,
the telephone displays the caller ID information or Blocked call accordingly. You can press
or /SPEAKER to take the new call, or press CALL BLOCK on the handset or telephone base to block it.
- If the telephone is screening a call, the call waiting call will be ignored and logged as missed call in the
caller ID log.
Options while on calls
To Next Page
Loading...
Need help?
General
