Multiple handset use
Push-to-talk (PTT)
Make an outgoing call during PTT call
f During a one-to-one PTT call, press
PHONE/FLASH on your handset or
/SPEAKER on your telephone base to get a dial tone. The PTT call
ends automatically.
f During a one-to-group PTT call, press
PHONE/FLASH on the initiating
handset or /SPEAKER on the initiating telephone base. The PTT call
ends automatically and you get a dial tone.
f During a one-to-group PTT call, press
PHONE/FLASH on any one of the
destination handsets or press /SPEAKER on the destination telephone
base. That device gets a dial tone. The PTT call continues for the rest of the
PTT participants.
End or leave a PTT call
For one-to-one PTT calls, both initiating and destination devices can end
the PTT call. For PTT calls to multiple devices, the initiating device can end
the PTT call. If any one of the destination devices leaves the PTT call, the call
continues until all participants or the initiator hangs up.
Press
OFF/CANCEL on the handset, or press CANCEL on the telephone base.
The screen shows Push to talk Ended.
-OR-
Place the handset in the telephone base or charger, then the handset
returns to idle mode.
Note: After PUSH TO TALK on the handset or FLASH/PTT on the telephone base is released, the PTT call
remains open for a short time. If no one presses PUSH TO TALK on the handset or FLASH/PTT on the
telephone base within ten seconds, the PTT call ends automatically.
61
To Next Page
Loading...
Need help?
General
