EasyManuals Logo

AT&T CL83207 User Manual

AT&T CL83207
179 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #18 background imageLoading...
Page #18 background image
Getting started
11
Battery installation and charging
Install the battery, as shown below. Once you have installed the battery, the Install the battery, as shown below. Once you have installed the battery, the
screen indicates the battery status (see the following table). If necessary, screen indicates the battery status (see the following table). If necessary,
place the handset in the telephone base or charger to charge the battery. For place the handset in the telephone base or charger to charge the battery. For
best performance, keep the handset in the telephone base or charger when best performance, keep the handset in the telephone base or charger when
not in use. The battery is fully charged aer ten hours of continuous charging. not in use. The battery is fully charged aer ten hours of continuous charging.
See the table on page 167 for battery operating times.See the table on page 167 for battery operating times.
If the screen shows Place in charger and If the screen shows Place in charger and ashes, you need to charge the ashes, you need to charge the
handset without interruption for at least 30 minutes to give the handset handset without interruption for at least 30 minutes to give the handset
enough charge to use the telephone for a short time. The following table enough charge to use the telephone for a short time. The following table
summarizes the battery charge indicators and actions to take.summarizes the battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank, or
shows Place in charger
and (ashing).
Battery has no or very
little charge. The handset
cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
Low battery and (ashing).
Battery has enough charge
to be used for a short time.
Charge without interruption
(at least 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery charged,
place it in the telephone base or
charger when not in use.
Step 1
Plug the battery connector securely into the socket inside the handset
battery compartment. Insert the supplied battery with the label THIS SIDE UP
facing up, as indicated.
Note: If you are on a phone call in low battery mode, you hear four short beeps every minute.
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
BT183342/BT283342 (2.4V 400mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine CR1349
THIS SIDE UP

Table of Contents

Other manuals for AT&T CL83207

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AT&T CL83207 and is the answer not in the manual?

AT&T CL83207 Specifications

General IconGeneral
Colorsilver/black
Speakerphoneyes
Expandableyes
Volume Controlyes
Intercomyes
Incoming Lines1
Dialing Modepulse, tone
Record Time22 minutes
Display Typelcd
Caller IDyes
Call Waitingyes
Answering Systemyes
Flash Functionno
Conference Callyes
Conference Call Capabilityyes
Caller ID Memory50 gigabytes
Phone Book Memory50 gigabytes
Handsetsyes
Expansion Base Stations1
Expansion Handsets2, 12
Backlit Keypadyes
Frequencydect 6.0 digital

Related product manuals