Telephone operation
48
Options while on calls
To transfer an outside call from the telephone base:
1. During the call, press MENU/SELECT.
2. Press qCID or pDIR to scroll Transfer, then press
MENU/SELECT.
f If your have one handset and no other registered
devices, the outside call is put on hold and the
telephone base shows Transferring call.... The
handset rings and shows Transfer from BASE 0
(BASE represents the base name).
f If you have other registered device(s) or more than
one handset, the telephone base shows TRANSFER
TO: Use the dialing keys to enter a specific handset
number (1-9 for handsets 1-9, TONE followed by 0-2
for handsets 10-12, or TONE followed by
#
for all handsets), or press qCID or pDIR to scroll to the desired handset
and press MENU/SELECT. The outside call is put on hold and the
telephone base shows Transferring call... or Transferring call to all....
The other handset(s) rings and shows Transfer from BASE 0 (BASE
represents the base name).
3. To answer the call on the destination handset, press
PHONE/FLASH or
/SPEAKER. The telephone base shows Call transferred and goes to
idle mode.
Notes:
f To cancel the transfer and return to the external call before the blind transfer call is answered, press
OFF/CANCEL,
PHONE/FLASH or /SPEAKER on your handset, or CANCEL or /SPEAKER on your telephone base.
f If the other device does not answer the transfer within 30 seconds, the transfer ends and the initiating device rings
while showing No response to transfer. If it does not pick up within 30 seconds, the device returns to idle mode and the
outside call ends.
>Transfer
Intercom
Speaker 0:00:12
6:30
AM
8/06
TRANSFER TO:
>Handset 2
To Next Page
Loading...
Need help?
General
