Multiple handset use
Push-to-talk (PTT)
Using the telephone base:
1. There are a few ways to begin a PTT call to a single
handset. When the telephone base is not in use:
f If you have one handset, press and hold FLASH/PTT.
f If you have more than one handset:
} Press FLASH/PTT, then use the dialing keys to enter
the destination handset number.
-OR-
} Press qCID or pDIR to highlight the destination
handset number, then press MENU/SELECT or
FLASH/PTT.
The telephone base shows Connecting to HANDSET
X...
(HANDSET represents the handset name, X represents the destination
handset number)
for a few seconds. When the connection is made, both the
telephone base and destination handset display
Press and hold [PTT] to talk.
2. Press and hold FLASH/PTT. A chirp indicates your
microphone is on. Speak towards the telephone base.
Your voice is broadcast to the destination handset.
While you are speaking, the telephone base shows
PTT To handset: X.
3. Release PTT after speaking. Both devices beep once again and the screens
show Press and hold [PTT] to talk, then you can press and hold
FLASH/PTT to continue speaking or the destination device can respond
(see Answer a PTT call on page 59).
4. To end the PTT call, press CANCEL. The telephone base shows
Push to talk Ended for a few seconds.
PTT To
handset: X
PUSH TO TALK
>HANDSET X
Connecting to
HANDSET X...
Press and hold
[PTT] to talk
56
To Next Page
Loading...
Need help?
General
