AT&T EL52100 - Wall Mount to Tabletop Conversion

9
Getting started
Wall mount installation
Wall mount to tabletop installation
To change the telephone base from the wall mount installation to tabletop
installation, follow the steps below.
Unplug the large end of the larger power adapter from the electrical outlet.
If the telephone line cord and power adapter cord are bundled, untie
them first. Slide the wall mount bracket up and remove it from the wall
mounting plate. Unplug the end of the telephone line cord from the
telephone wall jack.
1.
2.
Lift the telephone base up to detach it from the wall mount bracket.3.
Refer to Telephone base installation on page 4 to install the telephone base.4.