52
Appendix
Telephone base indicator lights
ANS ON/OFF light
On when the built-in answering system is on.
IN USE light
On when the handset is in use or when the answering system
is answering an incoming call or when the answering system
is being accessed remotely.
Flashes when another telephone on the same line is in use.
Flashes quickly when there is an incoming call.
Screen icons, indicator lights and alert tones
Handset alert tones
One short beep
(Key tone or playback
confirmation tone)
A key is pressed.
Plays at the end of each message.
One long beep
(Recording or playback
confirmation tone)
Start or end recording.
Plays at the end of all messages.
Two short beeps
(Error tone)
Command has failed.
You have reached the beginning or end of the list.
You have reached the minimum or maximum listening volume.
Three short beeps
(Out-of-range or no-power-at-
base warning tone)
The handset is out of range or there is no power at the
telephone base.
Three short high-pitched beeps
(Confirmation tone)
The telephone has completed the command successfully.
Four short beeps
(Low-battery warning tone)
Low battery warning.
Telephone base alert tones
One short beep
(Playback confirmation tone)
Plays at the end of each message.
Beeps every 10 seconds
(Message alert tone)
Message alert.
One long beep
(Recording or playback
confirmation tone)
The answering system starts recording a message if call
screening is on.
Plays at the end of all messages.
To Next Page
Loading...
Need help?
General
