49
Answering system
Remote access
You can access the answering system remotely by dialing your home
telephone number from any touch-tone telephone.
To remotely access the answering system
Dial your telephone number from any touch-tone telephone.
When the answering system answers, enter the two-digit remote access code
(19, unless you have changed it; refer to Remote access code on page 18).
The answering system automatically announces the number of messages
(new or old) if there are any.
If there are new messages, the answering system automatically begins to
play new messages only.
-OR-
If there are no new messages, the answering system automatically begins
to play all old messages.
You can also enter the remote commands:
Play all messages
1
Press to listen to all messages. If there are new messages,
the system plays back only the new messages (oldest first).
If there are no new messages, the system plays back all old
messages (oldest first).
Play new messages
2
Press to listen to new messages only.
Delete a message
3
Press during message playback to delete the current message.
Delete all old messages
33
Press to delete all old messages.
Replay current message or
previous message
4
To repeat the message currently playing, press 4 after the
answering system plays the day and time the current message
was received.
To listen to the previous message, press 4 while the
answering system is playing the day and time the current
message was received.
Stop
5
Press to stop playback and recording.
Play help menu
* 5
Press to listen to a list of remote commands.
Skip to next message
6
Press during playback to skip the current message and
advance to the next message.
Record a announcement
* 7
Press to record a new announcement. Begin speaking after the
long beep.
Turn system on or off
0
Press to turn the answering system on or off.
Exit
8 or hang up
Press to end remote access (the call is terminated).
1.
2.
3.
4.
To Next Page
Loading...
Need help?
General
