To Next Page

To Previous Page

Appendix

Troubleshooting

Check that all the telephones connected to the same telephone line are

hung up.

Make sure to set the dial mode to the correct setting (pulse dialing or tone

dialing) for the service in your area (see Dial mode on page 14).

Eliminate any background noise. Noise from a television, radio or other

appliances may cause the telephone to not dial out properly. If you cannot

eliminate background noise, first try muting the cordless handset before

dialing, or dialing from another room in your home with less background

noise.

If the other telephones in your home are having the same problem, the

problem is in your wiring or telephone service. Contact your telephone

service provider (charges may apply).

My cordless handset isn’t performing normally.

Make sure the power cord is securely plugged into the telephone base.

Plug the power adapter into a different, working electrical outlet not

controlled by a wall switch.

Move the cordless handset closer to the telephone base. You might have

moved out of range.

Reset the telephone base. Unplug the electrical power. Wait for 15

seconds then plug it back in. Allow up to one minute for the cordless

handset and telephone base to reset.

Other electronic products can cause interference to your cordless telephone.

Try installing your telephone as far away from these types of electronic

devices as possible: television sets, VCRs, or other cordless telephones.

OUT OF RANGE OR NO PWR AT BASE appears on my cordless handset.

Ensure that the telephone base is powered up.

Place the cordless handset in the telephone base for one minute to allow

the cordless handset and base to synchronize.