HOW TO USE
2
Dial one of the following codes to set the volume you prefer:
– Dial *16 to turn off the background music.
– Dial *17 to set the volume to low.
– Dial *18 t
O set the volume to medium.
– Dial *19 to set the volume to high.
3 Touch Administer.
The console beeps twice.
4
Leave administration mode by sliding the T/P switch to the center
position.
You can use a programmed button or a dial code to access the Loudspeaker
Page feature.
To use a Loudspeaker Page button:
1
Touch Loudspeaker Page.
2
When you hear a beep, lift your handset and make your announcement.
To use this feature by dialing a code:
1
Touch Intercom.
2
Lift your handset.
3 Dial 6.
When you hear a beep, make your announcement.
When you hang up, the loudspeaker turns off automatically.
Music-on-Hold (and Background Music)
DESCRIPTION
When you have Music-on-Hold, you can provide background music for Callers
whom you have placed on hold. You can also provide background music
throughout the building using the loudspeaker paging system.
The Music-on-Hold (MOH) Jack is a Phonograph Jack, into which you can
plug a radio, tape player, or stereo system. It is on the front of the control
unit, under the red Warning and the green Power lights.
5-96 Section 5: Reference
To Next Page
Loading...
