10
Getting started
Telephone base and charger installation
Option 2: If you have a 2-line wall jack, plug the 4-conductor black telephone
line, as shown below.
Charger installation
IMPORTANT INFORMATION:
Use only the power adapter(s) supplied with this product. To obtain a replacement, visit
our website at www.telephones.att.com or call 1 (800) 222-3111.
In Canada, dial 1 (866) 288-4268.
The power adapters are intended for a vertical or floor mount position. The prongs are
not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or
cabinet outlet.
•
•
Plug the power adapter into an electrical outlet not
controlled by a wall switch.
Route the cord
through the slot.
Raise the antenna.
Line 1 + line 2
telephone wall jack
Plug one end of the black
telephone line cord into the
LINE 1/L1+L2 telephone jack at
the bottom of the telephone base.
Plug the other end of the
black telephone line cord
into the telephone wall
jack, or into a DSL filter if
you have DSL high-speed
Internet service.
To Next Page
Loading...
