13
Getting started
Battery installation and charging
Install the battery, as shown below. Once you have installed the battery,
the screen indicates the battery status (see the following table). For best
performance, keep the cordless handset in the charger when not in use. The
battery is fully charged after 11 hours of continuous charging. See the table in
the Technical specifications section on page 161 for battery operating times.
If the screen shows Place in charger and flashes, you need to charge the
cordless handset without interruption for at least 30 minutes to give the handset
enough charge to use the telephone for a short time. The following table
summarized the battery charge indicators and actions to take.
Battery indicators Battery status Action
The screen is blank or shows
Place in charger and flashes.
The battery has no or very little
charge. The handset cannot be used.
Charge without interruption
(at least 30 minutes).
The screen shows
Low battery and flashes.
Battery has enough charge to be
used for a short time.
Charge without interruption
(at least 30 minutes).
The screen shows HANDSET X. Battery is charged. To keep the battery
charged, place it in charger
when not in use.
Step 1
Plug the battery connector securely into the socket inside the handset battery
compartment. Insert the supplied battery with the label THIS SIDE UP facing
up, as indicated.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps every minute.
To Next Page
Loading...
