75
Multiple handset use
Intercom
Use the intercom feature for conversations between a cordless handset and the
telephone base, two cordless handsets, or a cordless handset/telephone base
and a cordless headset/speakerphone (sold separately). You can buy additional
expansion handsets (AT&T model TL86003), cordless headset, and cordless
speakerphones (AT&T model TL80133) for this telephone base to expand
your telephone system (up to 12 handsets or 10 handsets and two cordless
headsets/speakerphones).
To initiate, answer, and end an intercom call:
Using a cordless handset:
Press MENU in idle mode to enter the main menu.
Press CID or DIR to highlight Intercom, and then
press SELECT .
If you have one handset and no other registered
devices, the handset shows Calling base.
If you have cordless headset(s)/speakerphone(s) or
more than one handset, the handset shows
INTERCOM TO:. Use the dialing keys to enter aenter a
specific device number (0 for the telephone base, 1-9
for handsets 1-9, TONE followed by 0-2 for handsets
10-12, # for a single cordless headset/speakerphone,
# followed by 1 or 2 for cordless headset/speakerphone 1 or cordless
headset/speakerphone 2, respectively), or presspress qCID or pDIR to
highlight the desired device and press SELECT . Your handset screen
shows Calling HANDSET X or Calling Base.
The destination device(s) rings and shows HANDSET X is calling (HANDSET
represents the handset name, X represents the handset number).
2. To answer the intercom call, press LINE 1/FLASH, LINE 2/FLASH,
/SPEAKERSPEAKER, A CELL, B CELL, any dialing key (0-9, TONE ), or press
ANSWER on the destination handset. Both devices now show Intercom.
3. To end the intercom call, pressTo end the intercom call, press END, OFF/CANCEL, or place the cordless
handset into the charger; or presspressress END on the telephone base. The other
party hear four beeps. Both devices display Intercom ended.
1.
•
•
Play messages
Directory
Caller ID log
Intercom
BACK
SELECT
INTERCOM TO:
BASE 0
HANDSET 2
BACK
SELECT
To Next Page
Loading...
