AT&T TL86103 - Voice Command

60
Telephone operation
Telephone operation
Voice command
TL86103 supports voice recognition when the phone system is connected to
AT&T Softphone Call Manager installed on your computer (see page 12). You
can make calls on line 1 or line 2 (according to the line preference set, see
page 49) through the voice command (name dialing) function by using the
telephone base or a cordless handset.
Before making a voice command, make sure your desired contacts are in the
phonebook directory of the AT&T Softphone Call Manager that is independent
from the home and downloaded directories. For detailed instructions, please
refer to the Installation and Operation Guide in the CD-ROM which comes
with the package.
To make a call using voice command:
Using a cordless handset or the telephone base:
Press MENU in idle mode.
Press CID or DIR on the cordless handset, or CID, DIR, /RECORD, or
/DELETE on the telephone base to highlight Voice Command, and then
press SELECT . The screen displays Processing Voice command.... You hear
“Who would you like to call?”, followed by a confirmation beep.
3. Say your desired contact name, which is stored in the phonebook directory
of the AT&T Softphone Call Manager, to dial.
NOTES:
Make sure the USB cable is connected to the telephone base and your computer (page 11).
Make sure the AT&T Softphone Call Manager is launched on your computer.
When there is an incoming call from any line, the voice recognition will stop immediately.
To say a command again when processing, press STOP and select Voice Command again from
the menu.
To cancel a voice command activity before making another voice command, say “Cancel”.
If the voice command setting is set as Disable in the AT&T Softphone Call Manager,
voice command requests will be rejected.
You can also make a voice command using an AT&T TL80133 speakerphone paired with your
TL86103 telephone base. Press MUTE on the speakerphone. You hear “Who would you like to
call?”, followed by a confirmation beep. Say your desired contact name, which is stored in the
phonebook directory of the AT&T Softphone Call Manager, to dial.
1.
2.
•
•
•
•
•
•
•