17
Getting started
Installation options
Wall-mount to tabletop installation
To change the telephone base from the wall-mount position to tabletop
position, follow the steps.
Unplug the power adapter from the power outlet. Unplug the telephone
line cord from the wall jack (or DSL filter). If the telephone line cord and
power adapter cord are bundled, untie them first. Push the telephone base
up to remove it from wall.
Put the corded handset aside. Hold down the switch hook on the
telephone base, and then slide the handset tab upwards to remove it
from the slot. Rotate the handset tab by 180 degrees. Then, replace the
handset tab into the slot until it locks into position.
Gently pull upward to release the wall-mount bracket. Rotate the wall-
mount bracket up to tabletop position and push it into the telephone base
until it clicks into place.
Plug the telephone line cord (or DSL filter) into the wall jack. Plug the power
adapter into an electrical outlet not controlled by a wall switch. Bundle the
telephone line cord and power adapter cord neatly with twist ties, if necessary.
1.
2.
3.
4.
3
1
4
2
To Next Page
Loading...
