76
Multiple handset use
Intercom
Using the telephone base:
Press MENU in idle mode to enter the main menu.
Press CID, DIR, /RECORD, or /DELETE to
highlight Intercom, and then press SELECT .
If you have one handset and no other registered
devices, the telephone base shows
Calling HANDSET X.
If you have cordless headset(s)/speakerphone(s) or
more than one handset, the telephone base shows
INTERCOM TO:. Use the dialing keys to enter aenter a
specific handset number (1-9 for handsets 1-9,
TONE followed by 0-2 for handsets 10-12, # for a single cordless
headset/speakerphone, # followed by 1 or 2 for cordless headset/
speakerphone 1 or cordless headset/speakerphone 2, respectively),
or presspress CID, DIR, /RECORD, or /DELETE to highlight the
desired handset and press SELECT . The telephone base shows
Calling HANDSET X.
The destination device(s) rings and shows BASE is calling.
2. To answer the intercom call, press 1 LINE, 2 LINE, SPEAKER ,
CELL A , CELL B , any dialing key (0-9, TONE ), ANSWER , or lift the
corded handset. Both devices now show Intercom.
3. To end the intercom call, press END, OFF/CANCEL, or place the cordless
handset into the charger; or presspressress END on the telephone base. The other
party hear four beeps. Both devices display Intercom ended.
NOTES:
Before the intercom call is answered, you can cancel it by pressing OFF/OFF/CANCEL on the cordless
handset or END on the telephone base..
If the called device does not answer within 100 seconds, or it is in use, on a call, or out of
range, the initiating device shows No answer. Try again. and returns to the outside call.
To temporarily silence the intercom ringer, press SILENCE , OFF/CANCEL, or MUTE/DELETE on the
cordless handset, or press SILENCE or CANCEL on the telephone base.
You can only use one pair of devices at a time to make intercom calls.
1.
•
•
•
•
•
•
INTERCOM TO:
HANDSET 1
HANDSET 2
All
p
q
SELECT
BACK
Answering sys
Directory
Caller ID log
Intercom
p
q
SELECT
BACK
To Next Page
Loading...
