Quick start manual - F5200
MR-F5200B-U Quick start manual ATEQ F5200 Page 12/17
6. START AND STOP A MEASUREMENT CYCLE
Press the START key to launch the measurement cycle.
Press the RESET key to stop the current measurement. The "READY"
message indicates that the device is waiting for a new test cycle.
7. PASSWORD
The password gives or locks
access to the device.
The default identifier is admin;
and its password is admin.
The administrator can select
different rights following the
user. See the "User rights"
menu.
We invite the administrator to
create all the different
accounts for each user with
the corresponding rights.
The "Unsecure time" parameter is the time while the access is available for the selected
user, when this time is up, the locking will be on and the user must type its password
again to enter parameters.
To Next Page
Loading...
Need help?
General
