6 1800296 C
Precautions
Warning – Fire Hazard
Failure to follow the prescribed procedures may result in
a hazardous situation.
The generator must only be placed and used on firm,
stable, and level surfaces. Tipping of the unit may cause
liquid aerosol reagent spillage that can lead to BURNS
OR FIRE.
NEVER move the generator once it is producing aerosol.
Take caution against liquid aerosol reagent spillage.
Always use a funnel. In case of spillage clean up
contamination immediately.
DO NOT USE OXIDIZING OR FLAMMABLE GASES
SUCH AS COMPRESSED AIR. NEVER operate the
unit with anything except INERT GAS such as nitrogen,
carbon dioxide, or argon. Make sure all the compressed
gas connections are secure.
DO NOT drain the liquid aerosol reagent until the
generator has completely cooled to ambient conditions.
The 5C Thermal Aerosol Generator is factory pre-set for
liquid aerosol reagents specified by the part number. DO
NOT USE different liquid aerosol reagents other what is
specified. Contact ATI Customer/Technical Service for
questions regarding use of other liquid aerosol reagents.
Warning – Burn Hazard
Severe burns may occur if in contact with the output
collar.
DO NOT perform any maintenance until the generator
has completely cooled to ambient conditions.
Caution – Hot Surfaces
The output collar at the back of the unit may be
and
dangerous if in contact with flammable objects.
To Next Page
Loading...
Need help?
General