Atlantic alfea extensa + - Page 56

Line Function Setting range
or display
Setting
increment
Basic
setting
1150 I Floor curing function (gure 1, page 54) Off
- Off: Early interruption of the current programme, programme inactive.
- Operational heating.
- Heating ready for occupation.
- Operational heating + ready heating.
- Ready heating + operational heating.
- Manual: Manual mode enables you to programme your own concrete slab drying time.The function ends
automatically after 25 days.
1151 I Floor curing setpoint manually
(if line 1150 = manual)
0... 95 °C 1 °C 25 °C
This function enables you to set the custom concrete slab drying temperature. This temperature remains xed.
The concrete slab-drying program stops automatically after running for 25 days.
1156 I Floor curing day current 0... 32
1157 I Floor curing day completed 0... 32 0
1200 S Operating mode changeover None, Protection mode,
Reduced, Comfort, Automatic
Reduced
Operating mode at end of concrete slab drying period.
Cooling circuit 2
If the installation is tted with the cooling kit (Only with the cooling kit option).
1201 U Operating mode Protection, Automatic, Reduced,
Comfort
Protection
1202 U Comfort cooling setpoint 17... 40 °C 0,5 °C 24 °C
1203 U Reduced setpoint 5... 40°C 26 °C
1208 I Flow temp setp at OT° 25°C 6... 35 °C 0,5 °C 20 °C
1209 I Flow temp setp at OT° 35°C 6... 35 °C 0,5 °C 16 °C
1212 I Cooling limit at OT° 8... 35 °C 0,5 °C 24 °C
1213 S Lock time at end of heating / cooling 8... 100 1 h 24 h
1218 S Summer comp start at OT° 20... 50 °C 1 °C 26 °C
1219 S Summer comp end at OT° 20... 50 °C 1 °C 40 °C
1220 S Summer comp setp increase 1... 10 °C 1 °C 4 °C
1223 S Flow temp setp min OT° 25°C 6... 35 °C 0,5 °C 18 °C
1224 S Flow temp setp min OT° 35°C 6... 35 °C 0,5 °C 18 °C
1228 S Room inuence 1... 100 % 1 % 80 %
If the installation is tted with a room thermostat:
This function enables you to choose the ambient temperature's inuence on the setting.
If no value is entered, the setting is made based on the temperature control.
If the parameter is set at 100%, the setting is only based on the ambient temperature.
1232 S Room temp limitation 0,5... 4 °C 0,5 °C 0,5 °C
1238 S Mixing valve decrease 0... 20 °C 1 °C 0 °C
1241 S Actuator running time 30... 873 s 1 s 240 s
1263 S With prim contr / system pump No, Yes No*
*Basic setting : 1 circuit = No ; 2 circuits = Yes.
Installation and operation manual "1734 - EN"
Heat pump air/water split 1 service alféa extensa +
- 56 -