37
CALIBRATION
Advanced functions
Accessing advanced functions
at the same time for
at least 3 seconds
Press and hold these two buttons
for more than 3 seconds.
There may be a difference between the setpoint temperature and the temperature
actually measured in the room. This is generally due to the appliance installation
conditions (location, power/volume, room insulation, etc.). Calibration is used to adapt
the thermostat setting to the actual room conditions.
1 - Switch the appliance to Comfort mode at 20°C, and wait for a few hours.
2 - Measure the room temperature using a thermometer and calculate the difference
(measured temperature - set temperature).
3 - Press and hold the and buttons at the same time for more than 3 seconds to
display (Calibration).
4 - Press , will flash alternately with the actually set difference .
5 - Set the new value using the buttons (between -3°C and +3°C).
6 - Press to exit.
Example: After several hours in Comfort mode with the temperature set to 20°C,
I measure a room temperature of 18°C. So, I need to set a difference of 18 - 20 = -2.
>
3 s
X2
Example: After several hours in Comfort mode with the temperature set to 20°C,
I measure a room temperature of 22°C. So, I need to set a difference of 22- 20=+2.
>
3 s
X2
Press any button to activate the display.
To Next Page
Loading...
