Atlantic F620 - Factory Settings; Heating Standby Indicator; Maximum Temperature

38
EN
18
HEATING STANDBY INDICATOR
FACTORY SETTINGS
The appliance can save a maximum temperature (of between 19°C and 28°C), which the
settings cannot exceed. By default, it is set to 28°C.
1- Press and hold the and buttons at the same time for more than 3 seconds to
display .
2 - Press to display (Max. Temperature).
3 - Press , will flash alternately with the currently set maximum temperature .
4 - Set the new value using the buttons (between 19°C and 28°C).
5 - Press to exit.
Example: I want to prevent a temperature above 24°C from being set.
> 3 s
X4
There is an automatic timeout on the control panel display after a few seconds, with the
exception of the heating indicator, which is lit when the resistor is powered on. It is
possible to configure the panel so that the indicator goes out when the panel display is
switched off.
1 - Press and hold the and buttons at the same time for more than 3 seconds to
display .
2 - Press twice to display (Heating Indicator).
3 - Press , will flash alternately with .
4 - Press to display .
5 - Press to exit.
> 3 s
X2
It is possible to reset the appliance, erasing all the settings made (programs, calibration,
maximum temperature, heating indicator). This function is particularly useful in case of
programming errors.
1 - Press and hold the and buttons at the same time for more than 3 seconds to
display .
2 - Press 3 times to display (Factory Settings).
3 - Press , will flash alternately with .
4 - Press to display .
5 - Press to confirm. All the indicators will light up. The appliance will then return to
Comfort mode at 19°C.
>
3 s
X3
MAXIMUM TEMPERATURE