- 31 -
4.2.7 Lowering the mast
1. If the floodlights are not to be used again, lower
the mast using the DOWN button on the control
panel (1).
4.2.8 Stopping the engine
Follow the instructions below to switch the engine off
correctly:
1. Lower the mast. See section 4.2.7.
2. Disconnect the electrical appliances connected to
the socket (1), if applicable.
3. Push the STOP button on the Lc1003™ module
(2) to go into cool down.
4. After cool down, which takes approx. 30 sec.:
• For Lc1003™, put the starter switch S20 in
position O (OFF) (3).
• For Lc1001™, turn the ignition key to position
O (OFF).
5. Place all the automatic switches in their OFF
position (4).
6. If the optional External power input (230 VAC) is
installed, switch S10 to O (OFF) (5). See also
chapter “External power input (230 VAC), with
battery charger” on page 68.
Mind your head while lowering the
mast!
When lowering the mast, check that
the power cord on the mast (spiral
cable (2)) collapses freely into its
holder and does not become pinched
or tangled!
S50
S51
S20
0
1
F10
H15 S25
0 1
Q2 Q3 Q4 Q5Q1
P7
Q6
Q1 Q2 Q3 Q4 Q5 Q6 P8
ON
P7
S30
0
DOWNUP
Lc1003
1
If an optional “Photocell” is
provided and the Auto start lighting
level option is enabled, the mast will
be lowered automatically.
A buzzer will indicate that the mast
is moving.
S50
S51
S20
0
1
F10
H15 S25
0 1
Q2 Q3 Q4 Q5Q1
P7
Q6
Q1 Q2 Q3 Q4 Q5 Q6 P8
ON
P7
S30
0
DOWNUP
Lc1003
2
3
4
5
1
00_00_HiLight H5+-H2_EN.book Page 31 Thursday, February 27, 2020 3:23 PM
To Next Page
Loading...
