- 70 -
S25 ..... Auto positioning switch
Put the switch in position AUTO to activate
ASM (Auto Rise and Lower Safety Mast).
Put the switch in position MAN to de-
activate ASM.
H1 ....... Buzzer
An intermittent alarm sound indicates that
the mast is being extended/lowered.
Setting the sensitivity regulator
The photocell sensitivity regulator is used for
regulating the luminosity sensitivity level of the
photocell.
When the red LED (1) on the regulator is blinking, the
regulator is reading the luminosity level measured by
the photocell.
There are 2 blinking levels:
– Level 1: slow blinking
The photocell detects there is enough light,
according to its set sensitivity level.
– Level 2: fast blinking
The photocell detects there is a prolonged
luminosity change that falls below the set
sensitivity level. Remote start will be triggered
and the floodlights of the light tower will switch
on automatically (if Remote start and Auto mode
are selected, see also chapter “Operating the light
tower” on page 27).
The recommended value to set the regulator is at
50 Lux.
– < 50 Lux: the floodlights switch on.
– > 50 Lux: the floodlights switch off.
The luminosity level can be adjusted to a desired
higher/lower level, according to the specific operating
conditions of the light tower.
7.4.7.2 Weekly timer
Setting the timer
At first use (or after Reset):
– Choose the language (French, English,...).
– Choose to delete or to keep the default set
program.
– Set the year, day and time.
– Choose the summer/winter time change over
parameters.
A1
A2
12
50
75
100
25
1
LX
11
14
B1
B2
1
menu Press the menu key to enter the editing
menu.
When in the editing menu, press the
menu key to return to Auto mode,
without saving the last change.
+ / - Navigation and value setting keys
ok Flashing information validation key.
00_00_HiLight H5+-H2_EN.book Page 70 Thursday, February 27, 2020 3:23 PM
To Next Page
Loading...
